ispCP - Board - Support - VHCS fork / ispCP Omega Development Area / Suggestions / Changing php and cgi after an user had been added

Post Reply  Post Thread 
Changing php and cgi after an user had been added
Author Message
Z4P Offline
Junior Member
*

Z4P
Junior Member
*


Posts: 60
Group: Registered
Joined: May 2007
Status: Offline
Reputation: 0
Post: #1
Changing php and cgi after an user had been added
Hey i noticed i can't change php or cgi acces after i have added a domain. You need to delete him and then add it again with php support. Is there no other way to do this?

Sincerly, Z4P.
| Free hosting Gethost | Free guestbook Get-gb |
06-27-2007 03:52 AM
Visit this user's website Find all posts by this user Quote this message in a reply
Zothos Offline
Administrator
*******
Administrators

Zothos
Administrator
*******
Administrators


Posts: 718
Group: Administrators
Joined: Feb 2007
Status: Offline
Reputation: 10
Post: #2
RE: Changing php and cgi after an user had been added
should be possible. -> ticket? Tongue
Real programmers don't comment their code - it was hard to write, it should be hard to understand

OS : Gentoo 32bit Stage1
ispCP Version : RC4
Mods : Dovecot | Pure-ftpd

No Support via PM - Payed Support via request
06-27-2007 04:15 AM
Find all posts by this user Quote this message in a reply
Post Reply  Post Thread 

View a Printable Version
Send this Thread to a Friend
Subscribe to this thread |
Forum Jump:

Contact Us | isp Control Panel ( ispCP ) a VHCS fork | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication

| All rights reserved : isp-control.net |